To detach the device from the Mounting Bracket, a suction cup can be used to pull the device off the bracket.Īfter connecting the intercom, connect the other end of the network cable to the PoE injector, which is available as an accessory. Two markings at the top edge of the housing help with positioning:įinally, mount the device to the Mounting Bracket by first inserting the top and then snapping the bottom into place. It must be attached above the terminals once connected.
#LOXONE INTERCOM CODE#
Optionally, an NFC Code Touch as access control or other devices can be connected to the designated terminals (24V output and Tree interface).Ī self-adhesive cover is included in the delivery to protect against water. In a network wired according to T568A, the green and orange pairs are swapped.Īs the Intercom is capable of Auto MDI-X, operation is ensured in either assignment.įor a compliant connection according to T568A, the orange and green terminal pairs can be interchanged, but this is not technically necessary. The core assignment in the color shown corresponds to T568B termination. Strip the wires, then plug them into the matching colored orange/white and green/white push-in terminals:ĭo not connect any power supply other than PoE to the device! The other two wire pairs are not needed and must be insulated.
Remove about 5 cm of the cable jacket and prepare the orange/white and green/white wire pairs for connection. Standard solid core network installation cable, CAT5 and up, can be used to connect to the local network. Make sure that the TOP marking of the frame is at the top:Ī junction box behind the bracket is not required, but highly recommended for tucking away connecting wires or a spare loop.Ĭare must be taken not to cover the speaker openings on the left side of the bracket.
#LOXONE INTERCOM INSTALL#
Install the Mounting Bracket by affixing it onto a level surface. The anthracite version of the intercom must not be mounted in places exposed to direct sunlight, as overheating may occur. We recommend a mounting height of the top edge of the device of 160cm / 63". The installation is surface-mounted in a flat frame made of aluminum, which is available as an accessory in a single or double version.ĭepending on the application, the mounting height should be selected in such a way that adults are well captured by the camera, while children can still press the bell button. The integrated Tree interface makes it possible to connect an NFC Code Touch as part of an access solution. The device is connected to the network and powered via PoE (Power over Ethernet). The microphone is embedded into the front panel, the concealed speakers are located on unit's left side. HA.The Loxone Intercom is a compact video door station featuring a glass finish, illuminated bell button and proximity sensor. I’m now pushing for a smart system but don’t want to end up with a system what cannot be integrated into e.g. In addition, I can place my server in our cellar room. This would enable us to get a house-wide LAN and use a common line for the internet. I have just figured out that we have an internet access point in the basement, just next to all other telecom systems. One of them is already on, I’m about to install an open home automation system in our flat, properly HA. I’m asking as the 7 flat house I live in, what is shared with 6 other parties, will get a new video-intercom.
#LOXONE INTERCOM FULL#
have full audio, video and control capabilities (depending on what is supported by the intercom).using HA to open door from away, asterisk work only on LAN, correct?.
#LOXONE INTERCOM ANDROID#
0 kommentar(er)
